Encore 48K200 Specifications download pdf (Page 3)

ENCORE

2

Assembly Instructions

Fig. 1

upper handle into position. (Remember

that there are 3 – height settings for the

handle for operator comfort.) Route the

wiring harness along the handle,

plugging it into the blade control switch,

using the screws to attach the harness to

the Operator Presence Control switch.

There is not a specific color for hooking

up the harness.

SPECIFICATIONS

Belt Tension Guide

Belt

Engine to Deck

T

ransmission Belt

Right Blade Drive Belt

Wheel Drive

Inch Deflection

1/2”

1/2”

1/2”

(48”,52”, And 60” only)

1/2”

How to Adjust

Turnbuckle at Idler

Sliding Idler

Threaded Rod to Idler

Self-Adjusting

1. Remove inner parts box and handle from

crate. Remove outside frame work so

that the mower is setting on the pallet.

2. On a 36" mower, use 3 – 5/16" X 1 3/4"

bolts and 3 – 5/16" whizlocks and bolt the

bumper into place. (On the 48" there are

4 - bumper bolts required.)The whizlocks

should go to the inside of the deck.

When assembling a 48" mower, make

sure that the bumper is flush with the

deck on both ends of the bumper.

3. Using 6 – 3/8" X 1" bolts (3 – used for

each caster) and 6 – 3/8" whizlock nuts,

bolt the casters into place. Position

whizlock nuts to the inside of the deck.

4. Using 2 – 5/16" X 1" bolts with 2 – 5/16"

flat washers and 2 – 15/16" nyloc nuts,

take the shifter lever with grip and bolt

onto the top side of the shifter bracket on

the transmission. Place the 5/16" flat

washers on the slotted hole side of the

shifter bracket under the 5/16" nut.

Position the shift lever so that it slides

freely along the top side of the shifter

plate but still hits the stop for reverse.

5. Mount the gas tank using the 2 – nylon

hold down straps, pulling tension on the

buckles until secure. Attach the quick

coupler, on the end of the fuel line, to the

bottom of the tank. (See Fig. 1)

6. Using the remaining 4 - 3/8" X 1" bolts

and the 4 – 3/8" nyloc nuts, bolt the

1 2 3 4 5 6 7 8 ... 15 16

Comments to this Manuals

No comments