E9 IN REV. A
10
The Yellow wire provides an instant
shutdown for the remote start,
whenever it is grounded. Connect the
wire to the hood pin switch previously
installed. This wire must be routed
though a grommet in the firewall and
connected to the hood pin switch. If
the pin switch is to be used with an
alarm system, connect this wire with
diode.
To: White/black wire /
Negative safety
To: Alarm instant
trigger Blue wire
Hood Pin Switch
Diode Diode
Important! This connection is a safety wire and must be connected as shown and tested as specifiled. Failure to
do so may result in personal injury or property damage. See detail of wiring in the following diagram. This wire may
also be used if the vehicle brake light circuit switches ground to the brake lights. An isolation diode must be used for
ground switched brake light circuits and must be connected to the output of the brake switch.
Orange wire – (-) 200mA Grounded Output When Armed –
This wire will become grounded when the alarm is armed. The current capacity of this wire is 200mA. This output
can control starter disable, when an intrusion is detected and the system is triggered. The vehicles prevent from
any unauthorized starting.
87
87a
85
30
86
IN4003 Diode
H2/15: Orange wire
from control module
“Start”
“On”
Purple wire
Cut
Yello wire
White wire
“Acc”
“Off”
Starter
H1/1 VIOLET wire (Starter output)
form Heavy Gauge wire harness
Red wire to
Ignition Switch
White / Violet wire – Positive Safety Shut Down Input – Must Be Installed
Yellow wire – (-) 200mA Ignition 3 Output –
This wire provides an instant shutdown
for the remote start, whenever it gets
+12volts. If the brake lights switch in
the vehicle switches +12 volts to the
brake light circuit, connect this wire to
the output side of the brake switch.
This will allow the remote start to shut
down if an attempt is made to operate
the vehicle without the key while
running under the control of the
remote start. In most vehicles, in order
to shift gear, the brake pedal must be
depressed. The brake input will in turn
cause the remote start unit to shut off.
See diagram.
+12 volts from fuse box
To White/Violet
wire
Brake light bulbs
Switch closes
When brake is
de
ress
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals