E9 IN REV. A
20
3.
Press and release the transmitter button corresponding to the feature you want to program.
Press
Transmitter
Button
One Chirp /
LED one pulse
Factory Default
Setting
Two Chirps /
LED two pulse
Three Chirps /
LED three pulse
Four Chirps /
LED four pulse
1
Exit the programming mode. (3 long chirp & 3 parking light flashes to
confirm this exit.)
2
+
Voltage check
type (go to
3B)
Tachometer
Check type (3A)
Timer checking
type (go to 3B)
Data Bus
Interface
Mode**
3
A> RPM learning – see RPM Learning
B> Start Crank
Time:
0.6-second
0.8-second (2 chirps), 1.0-second (3 chirps), 1.2-second (4
chirps), 1.4-second (5 chirps), 1.6-second (6 chirps),
1.8-second (7 chirps), 2.0-second (8 chirps), 3.0-second (9
chirps), 4.0-second (10 chirps),
4
Low check level
Hi check level
5
Start or Stop the system for TESTING & ADJUSTMENT
6
+
“TEST” Mode for
Zone 2 / instant
trigger & Zone 3 /
Door trigger
“TEST” Mode for
Zone 1 & Zone 4
(2 Stage Shock
Sensor)
7 +
+ 50 RPM
DBI ONLY
No RPM learning
8 +
- 50 RPM
DBI ONLY
No RPM
Learning or <
50RPM
9
+
Automatic
Transmission
Manual
Transmission
Exit: Press the
button on the transmitter. 3 long chirps & 3 parking light flashes will confirm exit.
RPM LEARNING / TACHOMETER CHECKING TYPE
1. Turn the Ignition switch ‘ON/OFF’ 3 TIMES and stay in OFF position.
2. Push the Valet switch 7 times and hold it on the 7
th
push until a long chirp is hearing then release the valet
switch.
3. Press and release the transmitter
and buttons at the same time once to set the “Tachometer Checking
Type”. [2] LED flash, [2] chirp to confirm this setting.
4. Press and release the transmitter
button once, [2] LED flash, [2] chirp to indicate your are in features “RPM
Learning mode”.
5. Start the vehicle with the key. (While the engine is running, the parking & LED will flash, If don’t, please check
tachometer White/Blue wire connection.
6. Press and hold the valet switch for 2 seconds until a long chirp and the LED light constant for two seconds. The
RPM signal is learned.
7. Turns off the ignition switch to stop the engine running.
Once you complete step 7, you can adjust and test “Check Level” as below:
CHECK LEVEL PROGRAMMING: (TEST and ADJUST)
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals