E9 IN REV. A
12
This output is programmable. If programmed rearm a factory installed security system. This wire will supply a pulse
whenever the remote start times out or is shut dowm using the transmitter and remote door locking.
White / Blue wire – (-) Instant Start & Turn Off Input –
This wire activates and turns off the remote starter each time it sees a momentary ground signal. Normally used for
testing during installation or when activating the module from an after-market system.
White/Green wire – (-) Diesel Wait To Start Input
(See Start Feature Programming)
In diesel vehicles it is necessary to interface with the wire that on the WAIT-TO-START light in the dashboard. This
wire illuminates the bulb until the vehicle’s glow plugs are properly heated. When the light goes out the vehicle can
be started. This wire is always at the connector leading to the bulb in the dashboard. It can also be found at the
Engine Control Module (ECM) in many vehicles.
To test and determine the polarity of this wire:
1. Set your multi-meter to DCV or DC voltage (12V or 20V is fine).
2. Attach the (+) probe of the meter to (+) 12V.
3. Probe the wire that you suspect leads to the bulb with the (-) probe of the meter.
4. Turn the ignition switch to the ON position.
5. If the meter indicates 12 volts until the light goes out you have isolated the connect wire and the wire’s polarity is
negative (ground while the bulb is on).
6. If the meter reads zero volts until the light goes out and then reads 12 volts, you have isolated the connect wire
and the wire’s polarity is positive.
Connect this wire to the wire in the vehicle that sends the signal to turn on the WAIT-TO-START bulb in the
dashboard. In most diesels the wire is negative (ground turns on the bulb) and this wire can be directly connected
to the wire in the vehicle. If the vehicles use a positive wire (12V to turn the bulb) a relay must be used to change
the polarity.
Wait To Start Wire
Wait to Start
Indicator
Ignition (+
White/Green Wire
Wait To Start In
ut
87a
86
87
30
85
+
Wait To Start
Wait To Start
Indicator
White/Green Wire
Wait To Start In
ut
Black / Red Wire– (-) 200mA Timer Control Channel 5
(See Alarm Feature Programming) This wire is built-in user-programmable timer output provides a ground through
this wire. Press the transmitter
and buttons at the same time. You may program the built-in timer to send a
ground signal for any time interval between 1 second and 2 minutes. For instance, this timer output may be used to
turn on the headlight with the remote control. Also on certain BMW, Mercedes Benz, Jaguar and Volkswagen cars,
you can use this unique timed output to allow remote closure of all power window and sunroof without the need for an
external module!
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals